Controller for reversible hydraulic pump motors up to 30 amps continuous output (50 amp peak).

This controller uses higher quality parts with much lower resistance (more than twice the efficiency) of the regular controller for the same power, but supports 4x the current. There is no enclosure option at this time.

This controller can directly connect to the pins of the raspberry pi (no additional arduino required)

1. overtemperature, overcurrent (stall) detection
2. fuse and reverse polarity protection
3. voltage, current, temperature and rudder feedback
4. optional port/starboard end of travel input switches
5. Serial communication with optical isolation, prevent ground loops and other electrical problems
6. Waterproof 4 pin connection to autopilot computer (serial communication)
7. Optional motor/pump temperature sensor.
8. Modular design, arduino based, open source software
9. Dimensions 115x90x40 mm
10. Clutch output supports pwm (reduce current to hold clutch on)
11. supports 12/24 volts