This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
pypilot_calibration [2019/07/25 13:51] seandepagnier |
pypilot_calibration [2019/07/25 13:52] (current) seandepagnier |
||
---|---|---|---|
Line 10: | Line 10: | ||
Finally, you should complete a circle in the boat to calibrate the compass. You can see when the sensors calibrate from the compass tab. | Finally, you should complete a circle in the boat to calibrate the compass. You can see when the sensors calibrate from the compass tab. | ||
- | |||
- | |||
- | If you have a rudder feedback sensor, you can calibrate it from the servo tab. First manually center the rudder and click "Rudder is Centered". Next, turn the rudder to starboard until the angle you wish it to stop (before it reaches end of travel) and input the actual angle. The angle is needed to provide accurate rudder feedback measurements over nmea for opencpn dashboard display for example. Now hit "Rudder At Range" and the rudder feedback should be calibrated. | ||